Motorola Solutions인증사에서 주췌하는 MSC-122시험은 IT업계에 종사하는 분이시라면 모두 패스하여 자격증을 취득하고 싶으리라 믿습니다. ITExamDump에서는 여러분이 IT인증자격증을 편하게 취득할수 있게 도와드리는 IT자격증시험대비시험자료를 제공해드리는 전문 사이트입니다. ITExamDump덤프로 자격증취득의 꿈을 이루세요.
IT인증자격증은 여느때보다 강렬한 경쟁율을 보이고 있습니다. Motorola Solutions 인증MSC-122시험을 통과하시면 취직 혹은 승진이나 연봉협상에 많은 도움이 되어드릴수 있습니다. Motorola Solutions 인증MSC-122시험이 어려워서 통과할 자신이 없다구요? ITExamDump덤프만 있으면 이런 고민은 이제 그만 하지않으셔도 됩니다. ITExamDump에서 출시한 Motorola Solutions 인증MSC-122덤프는 시장에서 가장 최신버전입니다.
ITExamDump는 우수한 IT인증시험 공부가이드를 제공하는 전문 사이트인데 업계에서 높은 인지도를 가지고 있습니다. ITExamDump에서는 IT인증시험에 대비한 모든 덤프자료를 제공해드립니다. Motorola Solutions인증 MSC-122시험을 준비하고 계시는 분들은ITExamDump의Motorola Solutions인증 MSC-122덤프로 시험준비를 해보세요. 놀라운 고득점으로 시험패스를 도와드릴것입니다.시험에서 불합격하면 덤프비용 전액환불을 약속드립니다.
시험 번호/코드: MSC-122
시험 이름: Motorola Solutions (Deploy WLAN Solutions)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 113 문항
업데이트: 2013-12-04
ITExamDump의 제품들은 모두 우리만의 거대한IT업계엘리트들로 이루어진 그룹 즉 관련업계예서 권위가 있는 전문가들이 자기만의 지식과 지금까지의 경험으로 최고의 IT인증관련자료를 만들어냅니다. ITExamDump의 문제와 답은 정확도 적중률이 아주 높습니다. 우리의 덤프로 완벽한Motorola Solutions인증MSC-122시험대비를 하시면 되겠습니다. 이렇게 어려운 시험은 우리Motorola Solutions인증MSC-122덤프로 여러분의 고민과 꿈을 한방에 해결해드립니다.
ITExamDump는 IT업계에서 유명한 IT인증자격증 공부자료를 제공해드리는 사이트입니다. 이는ITExamDump 의 IT전문가가 오랜 시간동안 IT인증시험을 연구한 끝에 시험대비자료로 딱 좋은 덤프를 제작한 결과입니다. Motorola Solutions인증 MSC-122덤프는 수많은 덤프중의 한과목입니다. 다른 덤프들과 같이Motorola Solutions인증 MSC-122덤프 적중율과 패스율은 100% 보장해드립니다. Motorola Solutions인증 MSC-122시험에 도전하려는 분들은ITExamDump 의Motorola Solutions인증 MSC-122덤프로 시험을 준비할것이죠?
MSC-122 덤프무료샘플다운로드하기: http://www.itexamdump.com/MSC-122.html
NO.1 You have an access point that requires PoE connected to a switch with a 150 meter 10 BASE-T CAT 5
cable. During testing numerous problems with both data transmission and intermittent power occurs.
Which of the following is most likely the cause?
A. The cable should be CAT 6
B. There is a duplex mismatch
C. The cable should be 100 BASE-T
D. The cable is too long
Answer: D
Motorola Solutions자료 MSC-122최신덤프 MSC-122 dumps
NO.2 During a recent throughput analysis test of your 802.11g network, you discovered that performance is
poor in comparison to previous baselines. You discover that this is the result of 802.11b stations becoming
associated with your access point. What option could you implement to eliminate 802.lib clients from
attaching to your network?
A. Implement protection mechanisms
B. Make 24 mbps a required data rate
C. Implement RTS/CTS at the access point
D. Change the channel used for the network
Answer: B
Motorola Solutions MSC-122자료 MSC-122 pdf MSC-122자료 MSC-122
NO.3 You have configured a Motorola RFS controller using WiNG 5 and have attempted to adopt a group of
APs using L2 adoption but the adoption is not successful. You have confirmed the following:
-All of the APs have an Ethernet connection to the same LAN segment as the controller -Spanning Tree
Protocol (STP) has been disabled on the APs next hop switch port -Intermediate firewalls are not blocking
EtherType 0x8783
Given this scenario, which of the following is the most likely cause of the unsuccessful AP adoption?
A. DHCP option 192 has not been defined on the DHCP server
B. A local VLAN has been configured on both the controller and the APs
C. The APs GE ports have been configured for an S02.1q-tagged native VLAN
D. The APs GE ports have been configured for an 802.1q-untagged native VLAN
Answer: C
Motorola Solutions MSC-122기출문제 MSC-122
NO.4 You are deploying a new WLAN within the WiNG 5 architecture. Which of the following is the only
UNSUPPORTED Motorola access point/port?
A. AP-300
B. AP-650
C. AP-5131
D. AP-7131
Answer: C
Motorola Solutions최신덤프 MSC-122 MSC-122
NO.5 Which of the following statements is NOT considered to be a best practice with respect to the wired
backbone serving the WLAN.?
A. When performing manual configuration of a point-to-point Ethernet link, ensure that both the speed and
the duplex mode settings on the two ports match.
B. When creating a link between Ethernet 10/100BASE-T or 10/100/1000BASE-T ports, enable (or accept
the default of) auto-negotiation on both ports.
C. When creating a link between Gigabit Ethernet fiber ports, enable (or accept the default of)
auto-negotiation.
D. When creating a link between Gigabit Ethernet fiber ports, disable auto-negotiation on both ports.
Answer: D
Motorola Solutions dump MSC-122 pdf MSC-122기출문제 MSC-122덤프 MSC-122 MSC-122자료
NO.6 You are deploying a new system and are creating the RF Domain(s). Which of the following options
would you use to group the APs into the same domain?
A. By VLAN, where all APs are on the same subnet.
B. By site, which can be a location where the group of installed APs can hear each other's beacons.
C. By name, so they can be easily sorted in the tree view of the controller.
D. By deployment phase, so configurations can be accidentally pushed to newly installed APs.
Answer: A
Motorola Solutions기출문제 MSC-122 MSC-122기출문제
NO.7 You are designing a WLAN that will support multiple BSS IDs. One of the characteristics you need to
take into consideration is that each BSS transmits a beacon every 100 ms. How many BSSs can be
enabled on the following Motorola access points under WiNG 5: AP7131, AP650, AP6532?
A. 2, one per radio
B. 1 per AP, it is shared between the radios to provide seamless roaming
C. 8, four per radio
D. 16, eight per radio
Answer: D
Motorola Solutions MSC-122 dumps MSC-122
NO.8 Your customer has requested that you configure unique VLANs for voice, normal user data with
802.1X security, guest access, and management traffic. Which of the following VLAN modes can support
this request?
A. Native Mode
B. Access Mode
C. Trunk Mode
D. Aggregation Mode
E. Encapsulation Mode
Answer: C
Motorola Solutions pdf MSC-122 MSC-122 MSC-122
NO.9 Which of the following is the primary method of collision avoidance in an 802.11 CSMA/CA WLAN?
A. Backoff Timer
B. Carrier Sense
C. Contention Window
D. Enhanced Distributed Channel Access (EDCA)
E. Distributed Coordination Function Interframe Spaces (DIFS)
Answer: B
Motorola Solutions자료 MSC-122최신덤프 MSC-122 dumps MSC-122최신덤프 MSC-122
NO.10 Which of the following statements regarding the configuration of Motorola RFS controllers is TRUE?
A. ADSP can be used to push CLI profiles to APs and controllers.
B. LANPlanner can be used to push CLI profiles to APs and controllers.
C. RFMS can be used to perform predictive site surveys using an RFS controller
D. WiNG 5 can be used to perform manual site surveys using an RFs controller
E. CLI can be used to perform both manual and predictive site surveys using an RFS controller.
Answer: A
Motorola Solutions MSC-122덤프 MSC-122 MSC-122인증 MSC-122
NO.11 Which of the following APs does not support adaptive mode?
A. AP7131
B. AP6532
C. AP650
D. AP6521
Answer: A
Motorola Solutions MSC-122자료 MSC-122최신덤프 MSC-122 MSC-122
NO.12 Your customer has requested that during the upcoming 802.llg to 802.11n upgrade deployment you
enable 40 MHz channels on 1, 6, and 11 of the 2.4 GHz ISM band. You respond by saying that there is not
enough spectrum to allow 40 MHz channels centered on 1, 6, and 11. How wide are standard 802.11g
(OFDM) channels?
A. 20 MHz
B. 83.5 MHz
C. 5 MHz
D. 11 MHz
E. 22 MHz
Answer: A
Motorola Solutions MSC-122 dump MSC-122 dump MSC-122자격증 MSC-122최신덤프
NO.13 If a Motorola access point induces a 50 mW RF signal onto a 3 dBi antenna, what will be the resulting
EIRP of the transmitted signal?
A. 0 dBm
B. 3 dBm
C. 20 dBm
D. 50 mW
E. 50 dBm
Answer: C
Motorola Solutions덤프 MSC-122최신덤프 MSC-122시험문제 MSC-122
NO.14 You have just conducted a throughput test using iPerf on a WLAN that shows a PHY signaling rate of 54
Mbps, however the average throughput rate shown in iPerf is only 23.5 Mbps. What is the most likely
explanation for this condition?
A. This throughput speed is considered nominal.
B. This throughput rate could indicate a mismatch between Wi-Fi confidentiality algorithms.
C. This throughput rate indicates excessive user activity.
D. This throughput rate indicates excessive out-of-band interference such as nearby cell phone towers.
Answer: A
Motorola Solutions MSC-122 pdf MSC-122 MSC-122시험문제
NO.15 You are performing a physical site survey of a new WiNG 5 WLAN deployment. Which of the following is
CORRECT?
A. The Signal to Noise Ratio (SNR) is a critical measurement that needs to be addressed.
B. It is acceptable that you use any RF infrastructure device (Access Point) to perform the site survey test.
C. Using default settings of a site survey application will provide an adequate site survey result.
D. Customer throughput requirements are the only criteria for which need to be surveyed.
Answer: B
Motorola Solutions MSC-122 dump MSC-122 MSC-122 dumps
ITexamdump의 C_TERP10_65덤프의 VCE테스트프로그램과 98-372덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 000-593시험에 대비한 고품질 덤프와 ICBB시험 최신버전덤프를 제공해드립니다. 최고품질 000-087시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기